Configuring The Lcd Panel On Ex Series Switches (Cli Procedure); Disabling Or Enabling Menus And Menu Options On The Lcd Panel - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Complete Software Guide for Junos
Related
Documentation

Configuring the LCD Panel on EX Series Switches (CLI Procedure)

Disabling or Enabling Menus and Menu Options on the LCD Panel

192
®
OS for EX Series Ethernet Switches, Release 10.3
NOTE: After the configuration is committed, the connectivity between the
PC and the switch might be lost. To renew the connection, release and renew
the IP address by executing the appropriate commands on the management
PC or by removing and reinserting the Ethernet cable.
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 187
Installing and Connecting an EX2200 Switch
Installing and Connecting an EX3200 or EX4200 Switch
Installing and Connecting an EX4500 Switch
Installing and Connecting an EX8208 Switch
Installing and Connecting an EX8216 Switch
The LCD panel on the front panel of EX Series switches displays a variety of information
about the switch in the Status menu and provides the Maintenance menu to allow you
to perform basic operations such as initial setup and reboot. You can disable these menus
or individual menu options if you do not want switch users to use them. You can also set
a custom message that will be displayed on the panel.
This topic describes:
Disabling or Enabling Menus and Menu Options on the LCD Panel on page 192
Configuring a Custom Display Message on page 193
By default, the Maintenance menu, the Status menu, and the options in those menus in
the LCD panel are enabled. Users can configure and troubleshoot the switch using the
Maintenance menu and view certain details about the switch using the Status menu.
If you do not want users to be able to use those menus or use some of the menu options,
you can disable the menus or individual menu options. You can re-enable the menus or
menu options.
Issue the operational mode command to see which menus and menu
show chassis lcd
options are currently enabled.
NOTE: On some platforms you must specify an FPC slot number in these
commands. See the lcd-menu statement for details.
To disable a menu:
Copyright © 2010, Juniper Networks, Inc.