Request System Software Rollback - Juniper JUNOS OS 10.3 - SOFTWARE Manual

request system software rollback

Syntax
Syntax (EX Series
Switch)
Syntax (TX Matrix
Router)
Syntax (TX Matrix Plus
Router)
Release Information
Description
Options
Additional Information
Copyright © 2010, Juniper Networks, Inc.
request system software rollback
request system software rollback
<all-members>
<local>
<member member-id>
request system software rollback
<lcc number | scc>
request system software rollback
<lcc number | sfc number>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
sfc option introduced for the TX Matrix Plus router in Junos OS Release 9.6.
Revert to the software that was loaded at the last successful
command.
add
—Revert to the set of software as of the last successful
none
.
add
all-members —(EX4200 switches only) (Optional) Attempt to roll back to the previous
set of packages on all members of the Virtual Chassis configuration.
—(TX Matrix and TX Matrix Plus routers only) (Optional) On a TX Matrix router,
lcc number
attempt to roll back to the previous set of packages on a T640 router (or line-card
chassis) connected to the TX Matrix router. On a TX Matrix Plus router, attempt to
roll back to the previous set of packages on a T1600 router (or line-card chassis)
connected to the TX Matrix Plus router. Replace
.
3
local —(EX4200 switches only) (Optional) Attempt to roll back to the previous set of
packages on the local Virtual Chassis member.
member member-id —(EX4200 switches only) (Optional) Attempt to roll back to the
previous set of packages on the specified member of the Virtual Chassis configuration.
Replace with a value from 0 through 9.
member-id
—(TX Matrix routers only) (Optional) Attempt to roll back to the previous set of
scc
packages on the TX Matrix router (or switch-card chassis).
—(TX Matrix Plus routers only) (Optional) Attempt to roll back to the previous
sfc number
set of packages on the TX Matrix Plus router (or switch-fabric chassis). Replace
number with .
0
On the J Series router, you can use this command to roll back to a previous software
package when the current upgrade has been successful or has failed. On M Series and
Chapter 10: Operational Mode Commands for Software Installation
number
request system software
request system software
with a value from through
0
125