Connecting And Configuring An Ex Series Switch (J-Web Procedure) - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Related
Documentation

Connecting and Configuring an EX Series Switch (J-Web Procedure)

Copyright © 2010, Juniper Networks, Inc.
Specify the SNMP Read Community, Location, and Contact to configure SNMP
7.
parameters. These parameters are optional.
Specify the system date and time. Select the time zone from the list. These options
8.
are optional.
The configured parameters are displayed. Enter
The configuration is committed as the active configuration for the switch. You can now
log in with the CLI or the J-Web interface to continue configuring the switch. If you use
the J-Web interface to continue configuring the switch, the Web session is redirected to
the new management IP address. If the connection cannot be made, the J-Web interface
displays instructions for starting a J-Web session.
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 189
Installing and Connecting an EX2200 Switch
Installing and Connecting an EX3200 or EX4200 Switch
Installing and Connecting an EX4500 Switch
Installing and Connecting an EX8208 Switch
Installing and Connecting an EX8216 Switch
There are two ways to connect and configure an EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the J-Web procedure.
NOTE: Before you begin the configuration, enable a DHCP client on the
management PC you will connect to the switch so that the switch can obtain
an IP address dynamically.
NOTE: Read the following steps before you begin the configuration. You
must complete the initial configuration using EZSetup within 10 minutes. The
switch exits EZSetup after 10 minutes and reverts to the factory default
configuration, and the PC loses connectivity to the switch.
EX2200 switch—The LEDs on the network ports on the front panel blink
when the switch is in the initial setup mode.
EX3200, EX4200, EX4500, or EX8200 switch—The LCD displays a
count-down timer when the switch is in initial setup mode.
Chapter 15: Initial Configuration
to commit the configuration.
yes
189