Juniper JUNOS OS 10.3 - SOFTWARE Manual page 997

Additional Information
Required Privilege
Level
List of Sample Output
Copyright © 2010, Juniper Networks, Inc.
brief | detail | extensive | summary
health (pid process-identifer | process-name process-name)
health information.
—(TX Matrix and TX Matrix Plus routers only) (Optional) On a TX Matrix router,
lcc number
display standard system process information for a specific T640 router that is
connected to the TX Matrix router. On a TX Matrix Plus router, display standard
system process information for a specific T1600 router that is connected to the TX
Matrix Plus router. Replace
—(EX4200 switches only) (Optional) Display standard system process information
local
for the local Virtual Chassis member.
member member-id —(EX4200 switches only) (Optional) Display standard system process
information for the specified member of the Virtual Chassis configuration. Replace
with a value from 0 through 9.
member-id
providers —(Optional) Display provider processes.
resource-limits (brief | detail) process-name
scc —(TX Matrix routers only) (Optional) Display standard system process information
for the TX Matrix router (or switch-card chassis).
—(TX Matrix Plus routers only) (Optional) Display system process information
sfc number
for the TX Matrix Plus router (or switch-fabric chassis). Replace
—(Optional) Display process information that might be wider than 80 columns.
wide
By default, when you issue the
Matrix Plus master Routing Engine, the command is broadcast to all the T640 (in a
routing matrix based on the TX Matrix router) or T1600 (in a routing matrix based on the
TX Matrix Plus router) master Routing Engines connected to it. Likewise, if you issue the
same command on the TX Matrix or TX Matrix Plus backup Routing Engine, the command
is broadcast to all the T640 (in a routing matrix based on the TX Matrix router) or T1600
(in a routing matrix based on the TX Matrix Plus router) backup Routing Engines that are
connected to it.
view
show system processes on page 903
show system processes brief on page 904
show system processes detail on page 904
show system processes extensive on page 904
show system processes lcc wide (TX Matrix Routing Matrix) on page 905
show system processes summary on page 906
show system processes (TX Matrix Plus Router) on page 906
show system processes sfc (TX Matrix Plus Router) on page 913
show system processes lcc wide (TX Matrix Plus Routing Matrix) on page 916
Chapter 42: Operational Mode Commands for System Monitoring
—(Optional) Display the specified level of detail.
number with a value from
—(Optional) Display process resource limits.
show system processes command on a TX Matrix or TX
—(Optional) Display process
0 through 3 .
number with 0 .
901