Juniper JUNOS OS 10.3 - SOFTWARE Manual page 335

Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
request chassis pic request chassis pic
Copyright © 2010, Juniper Networks, Inc.
Likewise, on a TX Matrix Plus router, if you specify the
by using the lcc number option (the recommended method), replace
with a value from 0 through 7. Otherwise, replace
0 through 31. For example, the following commands have the same result:
user@host> request chassis pic fpc-slot 1 lcc 1 pic-slot 0 offline
user@host> request chassis pic fpc-slot 9 pic-slot 0 offline
pic-slot slot-number —PIC slot number. For the M Series router, the T640 router, the T1600
router, and the TX Matrix and TX Matrix Plus routers, it can be 0, 1, 2, or 3. On the
MX960 router,
slot-number
Engine. For the T320 router, it can be 0 or 1. For EX3200 and EX4200 switches, it is
0 for built-in network interfaces and 1 for interfaces on uplink modules. For EX8208
and EX8216 switches, it is 0.
lcc number —(TX Matrix and TX Matrix Plus routers only) (Optional) On a TX Matrix router,
control the PIC in a specified T640 router that is connected to the TX Matrix router.
On a TX Matrix Plus router, control the PIC in a specified T1600 router that is
connected to the TX Matrix Plus router. Replace
3.
maintenance
show chassis hardware on page 787
show chassis pic on page 830
request chassis pic on page 239
When you enter this command, you are provided feedback on the status of your request.
user@host> request chassis pic pic-slot 0 online fpc-slot 0
FPC 0, PIC 0 is already online
Chapter 17: Operational Mode Commands for System Setup
slot-number
corresponds to the slot number of the Packet Forwarding
number
of the T1600 router
number
slot-number
with a value from
with a value from 0 through
239