Chassis Configuration; Table 135: Show Chassis Led Output Fields - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Complete Software Guide for Junos
824
®
OS for EX Series Ethernet Switches, Release 10.3

Table 135: show chassis led Output Fields

Field Name Field Description
FPC slot number of the switch whose content is being displayed. The number
Front panel
is always
contents for slot
member ID value.
Front panel
On EX8200 switches, no slot number is displayed.
contents (EX8200
switches)
Displays status of the ALM LED:
Alarms LED
Off—No alarm has been configured.
Green—No alarm has been triggered.
Red—Major alarm.
Yellow—Minor alarm
System LED Displays status of the SYS LED:
Off—Switch is powered off.
Green—Switch is operating normally.
Yellow—Switch is booting.
Displays status of the MST LED (on EX3200, EX4200, and EX8200 switches):
Master LED
Green—On an EX4200 Virtual Chassis switch, indicates the switch is the
master in the Virtual Chassis configuration. On other switches, indicates that
the Routing Engine is operational.
Off
On an EX4200 Virtual Chassis switch, indicates that this switch is not the
master in the Virtual Chassis configuration.
On EX3200, standalone EX4200, and EX8200 switches, indicates that
the Routing Engine is not operational.
On an EX2200 switch only, displays the currently selected port parameter of
Mode LED
the Status LED:
ADM
SPD
DPX
POE
Names of the interfaces on the switch.
Interface
State of the currently selected port parameter of the Status LED for the interface.
LED
The Status LED port parameters are:
(ADM/SPD/DPX/POE)
NOTE: EX4500 and EX8200 switches do not have the POE port parameter.
ADM
SPD
DPX
POE
, except for EX4200 switches in a Virtual Chassis, where it is the
0
—Administrative
—Speed
—Duplex
—Power over Ethernet
—Administrative
—Speed
—Duplex
—Power over Ethernet
Copyright © 2010, Juniper Networks, Inc.