Table 57: Show Task Replication Output Fields - Juniper JUNOS OS 10.3 - SOFTWARE Manual

show task replication
Syntax
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
show task replication show task replication
(Issued on the Master (Issued on the Master
Routing Engine) Routing Engine)
show task replication
(Issued on the Backup
Routing Engine)
Copyright © 2010, Juniper Networks, Inc.
show task replication
Command introduced in Junos OS Release 8.5.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Displays graceful Routing Engine switchover (GRES) and nonstop active routing (NSR)
status. When you issue this command on the master Routing Engine, the status of nonstop
active routing synchronization is also displayed.
This command has no options.
view
show task replication (Issued on the Master Routing Engine) on page 355
show task replication (Issued on the Backup Routing Engine) on page 355
Table 57 on page 355 lists the output fields for the
fields are listed in the approximate order in which they appear.

Table 57: show task replication Output Fields

Field Name
Stateful replication
RE mode
Protocol
Synchronization Status
user@host> show task replication
Stateful Replication: Enabled
RE mode: Master
Protocol
OSPF
BGP
IS-IS
LDP
user@host> show task replication
Stateful Replication: Enabled
RE mode: Master
Chapter 17: Operational Mode Commands for System Setup
show task replication
Field Description
Displays whether or not graceful Routing Engine switchover is
configured. The status can be
Displays the Routing Engine on which the command is issued:
, , or
Master Backup Not applicable
Routing Engine).
Protocol that are supported by nonstop active routing.
Nonstop active routing synchronization status for the supported
protocols. States are NotStarted
Synchronization Status
NotStarted
Complete
NotStarted
Complete
command. Output
or .
Enabled Disabled
(when the router has only one
, InProgress , and Complete .
355