Copyright © 2010, Juniper Networks, Inc.
—(J Series router and EX Series switch only) (Optional) Restart the software process
dhcp
for a Dynamic Host Configuration Protocol (DHCP) server. A DHCP server allocates
network IP addresses and delivers configuration settings to client hosts without user
intervention.
dhcp-service
—(EX Series switch only) (Optional) Restart the Dynamic Host Configuration
Protocol process.
—(J Series router only) (Optional) Restart the ISDN dial-out process.
dialer-services
diameter-service
—(Optional) Restart the diameter process.
—(Optional) Restart disk monitoring, which checks the health of the hard
disk-monitoring
disk drive on the Routing Engine.
dlsw
—(J Series router only) (Optional) Restart the data link switching (DLSw) service.
—(EX Series switch only) (Optional) Restart the port-based network access
dot1x-protocol
control process.
—(Optional) Restart the dynamic flow capture (DFC) process,
dynamic-flow-capture
which controls DFC configurations on Monitoring Services III PICs.
ecc-error-logging
—(Optional) Restart the error checking and correcting (ECC) process,
which logs ECC parity errors in memory on the Routing Engine.
ethernet-link-fault-management
OAM link fault management process.
ethernet-switching
—(EX Series switch only) (Optional) Restart the Ethernet switching
process.
—(Optional) Restart the event process (eventd).
event-processing
firewall
—(Optional) Restart the firewall management process, which manages firewall
configuration.
general-authentication-service
authentication process.
gracefully
—(Optional) Restart the software process.
—(Optional) Immediately restart the software process.
immediately
interface-control
—(Optional) Restart the interface process, which controls the router's
or switch's physical interface devices and logical interfaces.
—(Optional) Restart the IPsec key management process.
ipsec-key-management
—(J Series router only) (Optional) Restart the ISDN signaling process, which
isdn-signaling
initiates ISDN connections.
Chapter 17: Operational Mode Commands for System Setup
—(EX Series switch only) (Optional) Restart the Ethernet
—(EX Series switch only) (Optional) Restart the general
267