Chapter 15 Initial Configuration; Connecting And Configuring An Ex Series Switch (Cli Procedure) - Juniper JUNOS OS 10.3 - SOFTWARE Manual

CHAPTER 15
Initial Configuration

Connecting and Configuring an EX Series Switch (CLI Procedure)

Copyright © 2010, Juniper Networks, Inc.
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 187
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 189
Configuring the LCD Panel on EX Series Switches (CLI Procedure) on page 192
Configuring Date and Time for the EX Series Switch (J-Web Procedure) on page 194
Configuring System Identity for an EX Series Switch (J-Web Procedure) on page 194
There are two ways to connect and configure an EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the CLI procedure.
NOTE: To run the
configuration as the active configuration. If you have configured anything on
the switch and want to run
See "Reverting to the Default Factory Configuration for the EX Series Switch"
on page 427.
Before you begin connecting and configuring an EX Series switch through the console
using the CLI:
Set the following parameter values in the console server or PC:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
script, the switch must have the factory default
ezsetup
ezsetup , revert to the factory default configuration.
187