Dante Network Settings; What Is Dante; Connecting A Device To The Dante Connector - Yamaha Audioversity Rivage Pm Series Network Setup Manual

Table of Contents

3. Dante Network Settings

By installing an HY144-D/-SRC, a Dante device can be used as a RIVAGE PM system

component. Up to 24 units can be mounted to a single HY144-D/-SRC and up to 48 units

can be controlled for a single DSP engine. In addition, the maximum number of channels that

can be controlled per mounted device is 128.

Dante is a network audio protocol developed by Audinate. It allows the management of

device control signals and multiple audio signals at different sampling frequencies and bit

rates in a network that supports Gigabit Ethernet.

For details about Dante, see the Audinate website.

http://www.audinate.com/

Or Yamaha also provides a variety of information regarding Dante on our website.

http://www.yamahaproaudio.com/

See the following information to set up a network to connect and use Dante devices in a

RIVAGE PM system.

Only Dante devices or a computer with Dante Controller can be connected to the Dante

connector of the HY144-D/-SRC. Do not connect any other devices to the connector.

Also, make sure to establish a physically separate connection between the Dante network

and the control network.

Table of Contents