Example For Configuring Martini Mpls L2Vpn - 3Com S7906E Configuration Manual

Total connections:
ce-intf
Vlan10
# Display SVC L2VPN connection information on PE 2.
[PE2] display mpls static-l2vc
Total connections:
ce-intf
Vlan20
# Ping CE 2 from CE 1.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=150 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=140 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=80 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 80/126/150 ms

Example for Configuring Martini MPLS L2VPN

Network requirements
CEs are connected to PEs through VLAN interfaces.
A Martini MPLS L2VPN is established between CE 1 and CE 2.
Figure 1-5 Network diagram for configuring Martini MPLS L2VPN
Device Interface
CE 1 Vlan-int10
PE 1 Loop0
Vlan-int20
CE 2 Vlan-int10
Configuration procedure
1) Configure CE 1
1, 1 up, 0 down
state destination
up 192.3.3.3
1, 1 up, 0 down
state destination
up 192.2.2.2
data bytes, press CTRL_C to break
IP address
100.1.1.1/24
192.2.2.2/32
10.1.1.1/24
100.1.1.2/24
1-23
tr-label rcv-label tnl-policy
100 200
tr-label rcv-label tnl-policy
200 100
Device Interface
P Loop0
Vlan-int20
Vlan-int30
PE 2 Loop0
Vlan-int30
default
default
IP address
192.4.4.4/32
10.1.1.2/24
10.2.2.2/24
192.3.3.3/32
10.2.2.1/24