Configuring Martini Mpls L2Vpn - 3Com S7906E Configuration Manual

To do...
Create an SVC MPLS L2VPN
connection

Configuring Martini MPLS L2VPN

Martini MPLS L2VPN uses extended LDP to transfer Layer 2 information and VC labels. To configure
Martini MPLS L2VPN, you need to:
Create a Martini MPLS L2VPN connection
After you create a Martini MPLS L2VPN connection on a Layer 3 interface, packets received on the
interface will be forwarded through the connection.
Configure the remote peer PE
In Martini MPLS L2VPN implementation, VC labels need to be exchanged between PEs. As two PEs
may not be connected to each other directly, you need to establish a remote session between the two
PEs, so that VC FECs and VC labels can be transferred through the session.
Configuration Prerequisites
Before configuring Martini MPLS L2VPN, complete these tasks:
Configuring IGP on the PEs and P devices to guarantee the IP connectivity of the MPLS backbone
Configuring MPLS basic capability and MPLS LDP for the MPLS backbone on the PEs and P
devices to establish LDP LSPs
Enabling MPLS L2VPN on the PEs
Establishing remote LDP sessions between PEs
For VLAN access, configuring a subinterface; for ATM access, configuring a VC
To configure Martini MPLS L2VPN, you need the following data:
Types and numbers of the interfaces connecting the CEs
L2VC destination address and VC ID
Tunneling policy
Configuration Procedure
Follow these steps to configure Martini MPLS L2VPN on the PE:
To do...
Enter system view
Enter interface view for the
interface connecting the CE
Use the command...
mpls static-l2vc destination
destination-router-id
transmit-vpn-label
transmit-label-value
receive-vpn-label
receive-label-value
[ tunnel-policy
tunnel-policy-name ]
[ control-word |
no-control-word ]
Use the command...
system-view
interface interface-type
interface-number
1-9
Remarks
Required
Remarks
—
—