Orientalmotor AZX Series Operating Manual page 68

Direct data operation
„ Application example 1 of direct data operation
The position (travel amount) or the speed should be
adjusted each time a load is changed because the feed rate
is different in each load.
z Setting example
• Position (travel amount): Change as desired
• Speed: Change as desired
• TRIG-MODE: Start at ON edge of TRIG
z Operation processing flow
Descriptions are given using the scanner as the subject.
1. Write the position and the speed.
2. Turn the TRIG ON.
z Result
When the TRIG is turned ON, the changed value is updated
immediately, and operation is performed with the new
position and speed.
„ Application example 2 of direct data operation
The speed should be changed immediately with the touch
screen because a large load is inspected at a lower speed.
z Setting example
• Speed: Change as desired
• Trigger: Speed (setting value of trigger: −4)
• TRIG-MODE: Start at ON level of TRIG
z Operation processing flow
Descriptions are given using the scanner as the subject.
1. Write "−4" to the "Direct data operation trigger setting"
parameter.
2. Write the data of the speed.
3. Turn the TRIG ON.
4. Change the speed.
z Result
When the TRIG is turned ON, operation is started. If the speed is
changed, the changed value is updated immediately, and the
operation is performed at the new speed.
68