Orientalmotor AZX Series Operating Manual page 231

Parameter ID
Dec Hex
Initial coordinate
459 01CBh generation & wrap
range offset ratio
Initial coordinate
460 01CCh generation & wrap
range offset value
The number of the RND-
461 01CDh ZERO output in wrap
range
2017 07E1h Mechanism lead
2032 07F0h Mechanism settings
2033 07F1h Gear ratio setting
Initial coordinate
2034 07F2h generation & wrap
coordinate setting
Mechanism limit
2035 07F3h
parameter setting
Mechanism protection
2036 07F4h
parameter setting
JOG/HOME/ZHOME
2037 07F5h
operation setting
Mechanism lead
2553 09F9h
decimal digit setting
*1 The setting unit is followed the "Acceleration/deceleration unit" parameter.
*2 Selecting "2: Positive side = Counterclockwise (the driver parameter is applied) or "3: Positive side = Clockwise (the driver
parameter is applied)" prioritizes the fixed value of the ABZO sensor for parameters other than the "Motor rotation direction."
Name Description
Sets the offset ratio of the wrap
range.
Sets the offset amount of the
wrap range.
Sets the number of times to
turn the RND-ZERO output ON
in the wrap range.
Sets the lead of the ball screw.
To change the mechanism
settings parameter, select
"Manual setting. "
Sets the gear ratio for geared
motor. When "0: Gear ratio
setting disable" is set, the gear
ratio is considered as "1."
To change the initial coordinate
generation & wrap coordinate
parameter, select "Manual
setting. "
Disables the ABZO setting of
the mechanism limit parameter.
Disables the ABZO setting of
the mechanism protection
parameter.
To change the parameter for
JOG operation, return-to-home
operation, and high-speed
return-to-home operation,
select "Manual setting. "
Sets the number of decimal
places when the lead of the ball
screw contains a decimal point.
Parameter R/W commands
Initial
Setting range
value
0 to 10,000 (1=0.01 %) 5,000
−536,870,912 to
536,870,911 steps
1 to 536,870,911
divisions
1 to 32,767
0: Prioritize ABZO
setting
1: Manual setting
0: Gear ratio setting
disable
1 to 32,767: Gear ratio
(1 = 0.01)
0: Prioritize ABZO
setting
1: Manual setting
0: Follow ABZO setting
1: Disable
0: Follow ABZO setting
1: Disable
0: Prioritize ABZO
setting
1: Manual setting
0: × 1 mm
1: × 0.1 mm
2: × 0.01 mm
3: × 0.001 mm
Update
C
0 C
1 C
1 C
0 D
0 C
0 D
0 D
0 D
0 D
0 C
231