Orientalmotor AZX Series Operating Manual page 215

Parameter ID
Dec Hex
137 0089h Sequence history 10
138 008Ah Sequence history 11
139 008Bh Sequence history 12
140 008Ch Sequence history 13
141 008Dh Sequence history 14
142 008Eh Sequence history 15
143 008Fh Sequence history 16
144 0090h Feedback position 32-bit counter
145 0091h Command position 32-bit counter
147 0093h Loop count buffer
150 0096h Settling time (ms)
160 00A0h Main power supply count
161 00A1h Main power supply time (min)
162 00A2h Control power supply count
163 00A3h Inverter voltage (1 = 0.1 V)
166 00A6h IP ADDR SW0
167 00A7h IP ADDR SW1
169 00A9h Elapsed time from BOOT (ms)
184 00B8h I/O status 1
185 00B9h I/O status 2
186 00BAh I/O status 3
187 00BBh I/O status 4
188 00BCh I/O status 5
189 00BDh I/O status 6
190 00BEh I/O status 7
191 00BFh I/O status 8
1280 0500h Alarm history details (Alarm code)
1281 0501h Alarm history details (Sub code)
Alarm history details (Driver
1282 0502h
temperature)
Alarm history details (Motor
1283 0503h
temperature)
Alarm history details (Inverter
1284 0504h
voltage)
Alarm history details (Physical I/O
1285 0505h
input)
1286 0506h Alarm history details (R-I/O output)
Alarm history details (Operation
1287 0507h
information 0)
Name
This indicates the history of operation data numbers executed
until now. "−1" is displayed when stopped. During operation, the
value same as the "Present operation data number" is also
displayed in the sequence history 1.
This is 32-bit counter of the feedback position. It counts
independently of the wrap function. When the control power
supply is turned on again, it returns within the wrap coordinates.
This is 32-bit counter of the command position. It counts
independently of the wrap function. When the control power
supply is turned on again, it returns to the wrap coordinates.
This indicates the present number of loop times in loop operation
(extended loop operation). The value is kept until the operation
start signal is turned ON.
This indicates the time from when the command is completed
until the IN-POS output is turned ON.
This indicates the number of times that the main power supply
was turned on.
This indicates the time elapsed since the main power supply was
turned on in minutes.
This indicates the number of times that the control power supply
was turned on.
This indicates the inverter voltage of the driver.
This indicates the input status of the IP address setting switch
(×16).
This indicates the input status of the IP address setting switch
(×1).
This indicates the time elapsed since the control power supply
was turned on.
This indicates the ON-OFF status of the internal I/O.
(Arrangement of bits
This indicates the content of the alarm history specified by the
"Alarm history details" of the maintenance command.
(Alarm history
Description
_
p.218)
_
p.255)
Monitor commands
215