Table of Contents
Advertisement
„ "Cumulative load value count divisor" parameter
The upper limit to count the cumulative load is 2,147,483,647.
If the operating time is long, the cumulative load may increase, making it difficult to manage or exceeding the upper
limit.
In this case, use the "Cumulative load value count divisor" parameter. The "Cumulative load value count divisor"
parameter is a divisor used to divide the count value of the cumulative load. Dividing by the cumulative load value
count divisor makes it easier to manage the count value.
y When the "Cumulative load value count
divisor" parameter is set to "1"
Upper limit value
Increasing rate = 1
The upper limit value has been reached
while operation is continued to perform,
and the cumulative load cannot be counted
„ "Cumulative load value auto clear" parameter
• If the "Cumulative load value auto clear" parameter is set to "1: Clear" (initial value: Clear), the cumulative load is
cleared to 0 each time the MOVE output is turned ON. The cumulative load can be reset for each operation.
• If the "Cumulative load value auto clear" parameter is set to "0: Does not clear," the cumulative load is not reset
even if the MOVE output is turned ON, and it is continued to integrate. The cumulative load can be monitored for a
certain period of time or under a certain condition. When this parameter is set to "0: Does not clear," reset the
cumulative load with the LAT-CLR input.
y When the "Cumulative load value auto clear"
parameter is set to "1: Enable"
Speed
ON
MOVE output
OFF
Cumulative load
y When the "Cumulative load value count
divisor" parameter is set to "5"
Upper limit value
Increasing rate = 1/5
Increase slows down because the count value
of the cumulative load is divided by "5"
y When the "Cumulative load value auto clear"
parameter is set to "0: Disable"
Speed
ON
MOVE output
OFF
Cumulative load
ON
LAT-CLR input
OFF
Cumulative load
283
Advertisement
Table of Contents
