Orientalmotor AZX Series Operating Manual page 30

Stored data (SD) operation
z Position, Speed, Starting/changing rate, Stopping deceleration, Drive-complete delay time
The target position, the operating speed, and the acceleration/deceleration rate (acceleration/deceleration time)
necessary for stored data operation are set.
y Positioning operation
Speed
Operating speed
Starting speed
0
ON
READY output
OFF
y When the operating speed is higher than
the starting speed
Speed
Operating speed
Starting speed
z Link, Next data number
Type
No link
Manual sequential
Automatic sequential
Continuous sequential
operation
z Area offset, Area width
Setting the area offset or the area width can set the range of the MAREA output for each operation data.
When the operating direction is the forward direction
y Positioning operation
Speed
Operating speed
Starting speed
ON
MAREA output
OFF
30
Position (travel amount)
Drive-complete
Stop delay time
Starting/
changing rate
Position (travel amount)
Stop
Starting/
changing rate
Time
Operation is executed once with a single operation data number. (Single-motion
operation)
Operation based on the operation data number set in the "Next data number" is
executed whenever the SSTART input is turned ON. The SSTART input is enabled when
the READY output is being ON.
Operation based on the operation data number set in the "Next data number" is
automatically started after stop for the time set in the "Drive-complete delay time."
Operation based on the operation data number set in the "Next data number" is
executed without stopping the motor.
Position
Area o set
Target
Width Width
position
y Continuous operation
Speed
Operating speed
Starting speed
Time 0
ON
READY output
OFF
y When the starting speed is equal to or higher
than the operating speed
Speed
Starting speed
Position (travel amount)
Operating speed
Description
y Continuous operation
Speed
Operating speed
Starting speed
Target
position
ON
MAREA output
OFF
Starting/changing rate
Time
Time
Position
Area o set
Width Width