Table of Contents
Advertisement
Information
Description
Bit output signal
Configuration
INFO-CFG
request
Reboot request
INFO-RBT
If information of "Preset request" was generated for 100 ms or more in a state where the "Information
auto clear" parameter was set to "0: Disable (not turned OFF automatically), " the preset may have
been failed. There are the following two possible reasons that the preset was failed.
The ABZO sensor is not connected to the driver.
The preset was executed in a state where the position deviation between the command position
and the feedback position was 1.8° or more.
272
Cause
The parameter that required executing
Configuration was changed.
The parameter that required rebooting was
changed.
Clear condition
Configuration was executed.
Reboot was executed.
Advertisement
Table of Contents
