Orientalmotor AZX Series Operating Manual page 287

„ Monitor of operation information
There are two types of monitors for operation information having saved, event monitor and latch monitor.
The monitor value cannot be checked with the MEXE02 software. Check via EtherNet/IP.
z Event monitor
The command position and feedback position are saved in the event monitor. The value is overwritten each time the
latch trigger is generated.
If the LAT-CLR input is turned ON, the value is cleared to 0.
z Latch monitor
The following operation information is saved in the latch monitor. A value having latched first time is continued to
save.
When the LAT-CLR input is turned from OFF to ON, the operation information can be overwritten.
• Status ("1" is stored when in the latched status.)
• Command position
• Feedback position
• Target position
• Operation data number
• Number of loop times
When the "status" in the latch monitor is 1 (in latch status), the operation information will not be
overwritten even if a latch trigger is generated.
Latch function
287