Orientalmotor AZX Series Operating Manual page 127

Assignment
Signal name
number
144 HOME-END
145 ABSPEN
146 ELPRST-MON
149 PRST-DIS
150 PRST-STLD
151 ORGN-STLD
152 RND-OVF
153 FW-SLS
154 RV-SLS
155 ZSG
156 RND-ZERO
159 MAREA
160 AREA0
161 AREA1
162 AREA2
163 AREA3
164 AREA4
165 AREA5
166 AREA6
167 AREA7
168 MPS
169 MBC
170 RG
172 EDM-MON
173 HWTOIN-MON
176 MON-OUT
177 PLS-OUTR
180 USR-OUT0
181 USR-OUT1
192 TRQ-LMTD
193 SPD-LMTD
196 OPE-BSY
198 SEQ-BSY
199 DELAY-BSY
200 JUMP0-LAT
201 JUMP1-LAT
202 NEXT-LAT
204 DCMD-RDY
205 DCMD-FULL
206 OL-DTCT
207 M-CHG
Output when high-speed return-to-home operation or return-to-home operation
is completed, or position preset is executed.
Output when coordinates have been set.
Output when the electrical home coordinates are enabled.
After preset, this signal is turned ON when preset is required again before the
motor is operated.
Output when the mechanical home has been set.
Output when the mechanical home suitable to the product is set at the time of
factory shipment.
The output is inverted when the wrap range is exceeded. (Toggle action)
Output when the software limit in the forward direction is reached.
Output when the software limit in the reverse direction is reached.
Output every time the feedback position of the motor rotates by one revolution
from the position having preset.
Output if the motor is at the home of the wrap range when the "Wrap setting"
parameter is set to "1: Enable."
Output when the motor is within the area that was set to the operation data.
Output when the motor is within the area.
Output when the main power supply is in an ON state.
Output when the electromagnetic brake is in a state of releasing the motor shaft.
Output when the driver is in a regeneration state.
Output when both the HWTO1 and HWTO2 inputs are turned OFF.
Output when either the HWTO1 input or the HWTO2 input is turned OFF.
Output information corresponding to the request of the I/O position output
function.
Output when the pulse request function is ready to execute.
Output a logical product (AND) or a logical sum (OR) for two types of output
signals.
Output while the torque limiting is performed.
Output while the speed limiting is performed.
Output while internal oscillation is performed.
Output while stored data operation is performed.
Output when the driver is set in a standby state (Drive-complete delay time,
Dwell),
Output when the (Low) I/O event number trigger is detected.
Output when the (High I/O event number trigger is detected.
Output when the operation is transitioned by the NEXT input.
Output when direct data operation is ready to execute.
Output when data is being written to the buffer area of direct data operation.
Output when the output torque reaches the torque to detect the overload alarm.
The output is inverted when the operation data number is transitioned. (Toggle
action)
Function
Signals list
127