Removing The Cover; Replacing The Cover; Figure 9-4: Removing The Cover - ADIC Scalar 100 User Manual

This procedure describes how to remove and replace the cover. Refer to See
Figure 9-4 while performing this repair action.

Removing the Cover

1. Mark and remove the ADIC Gateway cables (see "Preparing for Removal and
Replacement" on page 198).
2. If the ADIC Gateway is not installed in a rack cabinet, go to step 3.
If the ADIC Gateway is installed in a rack cabinet, remove the ADIC Gateway
(see "Preparing for Removal and Replacement" on page 198).
3. Remove the four retaining screws located on the sides, next to the front panel
(A). Facing the back of the ADIC Gateway grasp the sides of the unit with both
hands. Thumbs should be on top of the box (B).
4. Push thumbs down and toward the box's front to dislodge the cover (C).
5. Slide the cover all the way forward and lift off the chassis.

Figure 9-4: Removing the Cover

Replacing the Cover

1. Place the back corners of the lid onto the lip at the front of the ADIC Gateway
chassis.
2. Hook both corners of the cover onto the lip.
3. Push the cover back until it stops (C).
ADIC Gateway
tive Parts" on page 197.
201