Additional hardware is available that allows you to configure the library to meet your specific needs. The
available hardware includes the following:
•
Rackmounting hardware (Rackmount Kit)
•
Side Panels (Floor Model Kit)
•
Casters (Floor Models only)
•
Additional Drives
•
Secondary Power Supply
•
A Bulk Load Mailbox
•
Additional Storage Columns (each column can hold up to three magazines)
•
Storage Networking Controllers (SNC)
•
For information on the available SNC components, refer to the applicable manual on the Scalar
100 product CD or at
Rackmounting your Library
If you are rackmounting your library, use the Rackmounting Kit that is available from ADIC. The Scalar 100
requires 14U space in a standard 19 inch rack.
Before rackmounting your library, read the following guidelines:
•
For continued safe operation, the recommended maximum internal ambient temperature of the rack
should not exceed 40
•
During installation of a rackmounted unit, do not block or otherwise restrict airflow to the power
supply front or rear vents.
•
To maintain rack stability, make certain mechanical loading of the rack results in a low center of
gravity.
•
Before installing a unit into a rack, consider the overall loading of the branch circuit supplying power
to the rack. See
•
Because this unit is intended to be attached to an earth ground, ensure that a reliable path to earth
ground is maintained within the rack.
Scalar 100 User's Guide
Installing and Removing Hardware
www.adic.com.
°
C.
Specifications
on page 117 for the library power requirements.
31