ADIC Scalar 100 User Manual page 255

The port must be in Initiator mode if you want the ADIC Gateway to scan for target
devices on the port. When the port is in Private Initiator mode, ADIC Gateway
only scans for devices on the local loop. If the port mode is in Public Initiator
mode, the ADIC Gateway also scans for devices attached to a Fabric.
Gateway > fcPortModeSet 1,2
value = 0 = 0x0
Gateway
fcRestart [port]
The fcRestart command restarts the specified Fibre Channel port. You typically
use this command to restart the port after changing its configuration settings so
that the changes take affect. Issuing this command is an alternative to rebooting
the ADIC Gateway in order to make the configuration changes take affect.
Attention: This command interrupts traffic.
The following example shows the display when Fibre Channel port 1 is specified.
Gateway > fcRestart 1
value = 0 = 0x0
FCT Restart 1 :
Controller Restart Successful
Gateway >
fcRestart [port]
Parameter Value
Port 1- 6
Mode 1
2
3
17
18
19
>
Parameter Value
Port 1 - 6
Meaning
The SAN Connection number
Private Target
Private Initiator
Private Target and Initiator
Public Target
Public Initiator
Public Target and Initiator
Meaning
The SAN Connection number
239