ADIC Scalar 100 User Manual page 283

scsiResetDisableGet [channel]
The scsiResetDisableGet command displays the SCSI Bus Reset On Power
Up is enabled. False means that SCSI Bus Reset On Power Up is disabled.
Gateway > scsiResetDisableGet
SCSIbus
SCSI 1
SCSI 2
value = -1 = 0xffffffff
Gateway >
For information about Ultra2/3 SCSI channels, see the xscsiResetDisableGet
command.
scsiResetDisableSet [channel],[mode]
The scsiResetDisableSet command sets the SCSI Bus Reset On Power Up
for the specified SCSI channel. False is default and enables reset of SCSI bus on
power-up, True disables SCSI bus reset on power-up.
Gateway > scsiResetDisableSet 1,1
Reset Disable set to TRUE for SCSI 1
scsiResetDisableGet [channel]
is returned on completion.
When a device is discovered, there may be further device specific
initialization that continues after the scan has completed in which case
the device may not show up immediately when you issue the
fcShowDevs command. An example of this is a disk that requires a
SCSI Start Unit command to become ready. (Tape and Changer
devices and Disks that indicate Ready status are available on scan
completion).
If a SCSI target device should require replacement, remove the old
device, set the new device to the same SCSI bus ID as the old device
and attach it to the same channel. Rescan the channel to update the
configuration data. The new device should be available to host
systems with the same LUN as the old device.
Reset Disable -------
TRUE
FALSE – default
Parameter
Channel number
Mode
---------------
Value Meaning
1 - 4 Selected Channel
0 Enable Reset on Power Up
1 Disable Reset on Power Up
267