enableCC
To restore the capability to send commands to the command and control interface
(LUN 0), use the enableCC command. The command is typically used to re-
enable the interface after it was disabled by the disableCC command.
Gateway > enableCC
value = 0 = 0x0
ethAddrSet
The ethAddrSet command changes the IP address of the ADIC Gateway. An IP
address is specified as 4 decimal numbers separated by periods.
Gateway > ethAddrSet "192.168.1.54"
Host Address set to 192.168.1.54 for Ethernet interface
value = 0 = 0x0
Gateway
If a netmask is required, specify it after the IP address in "dotted decimal" form.
For example:
Gateway
Inet Mask set to ffff0000 for Ethernet interface
Write complete
Host Address set to 10.0.0.2 for Ethernet interface
value = 0 = 0x0
Gateway
fcConnTypeGet [port]
The fcConnTypeGet command is used to display the current setting of a Fibre
Channel port's connection type. See also the fcConnTypeSet command
236
>
> ethAddrSet "10.0.0.2","255.255.0.0"
>
Parameter
Value
Port
1 - 6
Meaning
The SAN Connection number
enableCC