ADIC Scalar 100 User Manual page 270

LOG
VXWORKST.Z
SNA.RC
MGMT
MT
value = 0 = 0x0
Gateway
To obtain detailed information about the file, use the ll command instead.
macShow
The macShow command displays the Media Access Control (MAC) address for
the Ethernet interface.
Gateway > macShow
Enet MAC Address: 0.60.45.d.0.80
value = 33 = 0x21 = '!'
Gateway >
mapCompressDatabase
Occasionally, it may be necessary to eliminate inactive entries and reorder the
active entries in the Persistent Device Map database. The
mapCompressDatabase command removes entries for devices that are no
longer present and reassigns existing device entries to new addresses. The
devices will be assigned new addresses immediately and hosts must rescan for
devices or be rebooted.
This may be required when a host system has a limited number of logical units
that may be supported, and changing devices on the ADIC Gateway has caused
the logical unit numbers to increase beyond the host's supported level.
When you run this command you will be given the option of also clearing the VPS
access settings. Because devices will be assigned new addresses, clearing the
VPS database ensures that hosts will not have access to the wrong LUNs.
Accepting this option requires that the system administrator must reassign VPS
access permissions between the hosts and LUNs.
Gateway > mapCompressDatabase
This command will compress the Persistent Device Map.
Existing VPS Access Settings may become invalid and
254
>
Attention: Compressing the map database will cause device
addresses to change unpredictably. Use this command only when no
host systems are expecting devices to remain at their current
addresses.
macShow