For information about Ultra2/3 SCSI channels, see the xscsiAltIdGet com-
mand.
scsiAltIdSet [channel],[id]
The scsiAltIdSet command sets the Alternate Id for the specified SCSI
Channel.
Gateway > scsiAltIdSet 2,6
Alternate Id set to 6 for SCSI 2
will take effect upon reboot
value = 0 = 0x0
Gateway >
To set Alternate ID numbers for Ultra 2/3 SCSI Channels, see the
xscsiAltIdSet command
scsiHostChanGet [channel]
The scsiHostChanGet command displays Host Channel modes for a SCSI
channel. If no channel is specified, Host Channel modes are displayed for all
SCSI channels.
Gateway > scsiHostChanGet
SCSIbus
SCSI 1
SCSI 2
value = -1 = 0xffffffff
Gateway >
For information about Ultra2/3 SCSI channels, see the xscsiHostChanGet
command.
264
xscsiAltIdGet command.
Parameter
SCSI Channel number
ID
Attention: You must reboot the ADIC Gateway after executing this
command for the new setting to take effect.
HostChan -------
Channel is Target
Channel is Initiator
Value
1 - 4
0 -15
---------------
For information about Ultra2/3 SCSI channels, see the