Adic Gateway Network Setup; Figure 3-5: Adding A User Account - ADIC Scalar 100 User Manual

To add a new administrator account (pull down the menu and click on
Admin Add
). See Figure 3-5.
User

Figure 3-5: Adding A User Account

Remember that user names and passwords are case sensitive. After you add a
new administrator account, the pre-defined Admin account is deactivated.
Attention: Save your administrator account information in a secure location. If
you lose this information and do not have another administrator account available,
you must contact your service representative.
Use this new administrator account to set up other user accounts (with
or without Administrator privileges) that you might need.

ADIC Gateway Network Setup

The ADIC Gateway must be connected to a 10-base-T Ethernet network for use
with the ADIC Management Console software. An RJ-45 connector is located on
the rear panel of the ADIC Gateway for connection to the Ethernet. You will need
to first configure the IP address by connecting a terminal or terminal emulator to
the Service Port of the ADIC Gateway.
To configure the network, connect to the ADIC Gateway Service Port. See
"Connecting to the Service Port" on page 217.
For all of the following examples, substitute the values you determined in Step 8 of
Table 3-1: "Pre-Installation Steps" .
49
ADIC Gateway Network Setup