vpsTypeSet [hostIndex],
The vpsTypeSet command sets the Operating System type for the specified host
connection index. Existing hostindex values can be determined by looking at the
"Id" column in the output of the vpsShow -1 command. OS can be "nt" "aix"
"solaris" "hp-ux" "netware" "gateway" "switch" "generic" "unisys" "as400"
"autosense/nt" "fcr-2", or "pv-136t-fc". Additional information can be appended to
the end of the string.
The following command example shows setting the host type to NT 4.0 SP5 for
host Id 1.
Gateway > vpsTypeSet 1,"NT 4.0 SP5"
value = 0 = 0x0
Gateway >
xscsiAltIdGet [channel]
The xscsiAltIdGet command displays the alternate ID number for a specified
Ultra2/3 SCSI Channel.
Gateway > xscsiAltIdGet 5
SCSIbus
XSCSI
5
value = -1 = 0xffffffff
Gateway >
For information about alternate ID numbers for Ultra SCSI channels, see the
scsiAltIdGet command.
xscsiAltIdSet [channel], [id]
The xscsiAltIdSet command sets the Alternate Id for an Ultra2/3 SCSI Channel.
Gateway > xscsiAltIdSet 6,3
Alternate Id set to 3 for SCSI 6 will take effect upon reboot
value = 0 = 0x0
Gateway >
To set Alternate ID numbers for Ultra SCSI channels, see the scsiAltIdSet
command.
vpsTypeSet [hostIndex],"OS type string"
AltId
-------
Auto
Channel numbers
Id channel numbers
Attention: You must reboot the ADIC Gateway after executing this
OS type string
"
---------------
1 - 6 (Ultra2/3 SCSI)
0-15
command for the new setting to take effect.
"
289