ADIC Scalar 100 User Manual page 28

Avis de conformité à la réglementation d'Industrie Canada: Cet appareil
numérique de la classe A est conform à la norme NMB-003 du Canada.
European Community Compliance Statement
This product is in conformity with the protection requirements of EC Council
Directive 89/336/EEC on the approximation of the laws of the Member States
relating to electromagnetic compatibility. ADIC cannot accept responsibility for
any failure to satisfy the protection requirements resulting from a non-
recommended modification of the product, including the fitting of non-ADIC option
cards.
This product has been tested and found to comply with the limits for Class A
Information Technology Equipment according to European Standard EN 55022.
The limits for Class A equipment were derived for commercial and industrial
environments to provide reasonable protection against interference with licensed
communication equipment.
Attention: This is a Class A product. In a domestic environment, this product may
cause radio interference in which case the user may be required to take adequate
measures.
Where shielded or special cables (for example, cables fitted with ferrites) are used
in the test to make the product comply with the limits:
Properly shielded and grounded cables and connectors must be used in order to
reduce the potential for causing interference to radio and TV communications and
to other electrical or electronic equipment. Such cables and connectors are
available from ADIC authorized dealers. ADIC cannot accept responsibility for any
interference caused by using other than recommended cables and connectors.
Japanese Voluntary Control Council for Interference (VCCI) Class
1 Statement
12
Electronic Emission Statements