ADIC Scalar 100 User Manual page 298

uptime
The uptime command displays the elapsed time since the last boot of the ADIC
Gateway.
Gateway > uptime
Elapsed time since reset 4d:23h:12m:46s:10t
value = 10 = 0xa
Gateway >
The example indicates that 4 days, 23 hours, 12 minutes, 46 seconds and 10
clock ticks have elapsed since the ADIC Gateway was last booted. There are 60
ticks per second.
user
The userAdd,userDelete, and userList commands provide control of the
user list. The persistent address map file can be sent to the ADIC Gateway or
retrieved from it using FTP. If you need to use FTP, use the user commands to
create a login and password so you can access the ADIC Gateway from the
Ethernet network.
userAdd " username " , " password "
The userAdd command adds a user and password to the password file. The
parameter "username" must be from 3 to 80 characters. The parameter
"password" must be from 8 to 40 characters.
Gateway > userAdd "nancy","password"
value = 0 = 0x0
Gateway >
userDelete username , password
" " " "
The userDelete command deletes a user from the password file. It is not
possible to remove a user without knowing the user's password. If the user's
password is forgotten or unknown, you have to delete the password file, reboot
the ADIC Gateway, and then add all user names and passwords again.
Gateway > userDelete "nancy","password"
value = 0 = 0x0
Gateway >
282
uptime