ADIC Scalar 100 User Manual page 281

scsiHostChanSet [channel],[mode]
The scsiHostChanSet command sets the Channel Mode to Target or
Initiator for the specified SCSI Channel.
Gateway > scsiHostChanSet 2,1
Host Chan set to TRUE for SCSI 2 will take effect upon reboot
value = 0 = 0x0
Gateway >
To set Host Channel Modes for Ultra 2/3 SCSI Channels only, see the
xscsiHostChanSet command.
scsiHostIdGet [channel]
The scsiHostIDGet command displays the Host ID number for a specified
SCSI Channel. If no channel is specified, Host IDs are displayed for all SCSI
channels.
Gateway > scsiHostIdGet
SCSIbus
SCSI 1
SCSI 2
value = -1 = 0xffffffff
Gateway >
scsiHostChanSet [channel],[mode]
Parameter
SCSI Channel number
Mode
Attention: You must reboot the ADIC Gateway after executing this
command for the new settings to take effect.
HostId -------
7
7
Value
1 - 4 Selected Channel
0 Initiator
1 Target
---------------
Meaning
265