ADIC Scalar 100 User Manual page 259

gateAddrGet
The gateAddrGet command displays the default network gateway address if
one has been set. This address is used when connections are made to a different
subnet and there are no explicit routes defined for that subnet. Consult your
network administrator for more information on the default gateway (sometimes
referred to as default router) address.
Gateway > gateAddrGet
Gateway Address set to 192.168.1.1
value = 0 = 0x0
Gateway >
gateAddrSet
The gateAddrSet command changes the default network gateway address. This
address is used when connections are made to a different subnet and there are
no explicit routes defined for that subnet. Consult your network administrator for
more information on the default gateway (sometimes referred to as default router)
address.
Gateway > gateAddrSet "10.0.0.1"
value = 0 = 0x0
Gateway >
hardwareConfig
In order to use this command, the ADIC Gateway must be in diagnostic mode.
The hardwareConfig command records the configurations of installed FRUs by
copying them to the nonvolatile vital product data (VPD) stored on the ADIC
Gateway base. The fields that are updated are the SCSI channel types and PMC
gateAddrGet
PCI Addr
ISPType
Node Name
Port Name
The PCI address of the interface, showing
bus, device id, and function number.
The type of Fibre Channel Controller,
ISP2300.
The Fibre Channel node name for the ADIC
Gateway.
The Fibre Channel port name for the inter-
face.
243