ADIC Scalar 100 User Manual page 296

516 packets received
0 connection request
1 connection accept
1 connection established (including accepts)
1 connection closed (including 0 drop)
0 embryonic connection dropped
272 segments updated rtt (of 272 attempts)
0 retransmit timeout
0 persist timeout
1 keepalive timeout
value = 36 = 0x24 = '$'
Gateway >
trapDestAdd
The trapDestAdd command allows you to add an ethernet address as a trap
recipient to the SNMP trap destination table that is maintained within the ADIC
Gateway. When the ADIC Management Console is running, it inserts its address
into the table automatically. The broadcast address for the Ethernet port is also
automatically included in the table.
Gateway > trapDestAdd 192.168.1.75
value = 0 = 0x0
Gateway >
trapDestRemove
The trapDestRemove command allows you to remove an ethernet address as a
trap recipient from the SNMP trap destination table that is maintained within the
280
0 window probe packet
0 window update packet
0 control packet
272 acks (for 18372 bytes)
1 duplicate ack
0 ack for unsent data
276 packets (322 bytes) received in-sequence
0 completely duplicate packet (0 byte)
0 packet with some dup. data (0 byte duped)
0 out-of-order packet (0 byte)
0 packet (0 byte) of data after window
0 window probe
0 window update packet
0 packet received after close
0 discarded for bad checksum
0 discarded for bad header offset field
0 discarded because packet too short
0 connection dropped by rexmit timeout
1 keepalive probe sent
0 connection dropped by keepalive
ipAddress
"
ipAddress
"
"
"
trapDestAdd "ipAddress"