Table of Contents
Advertisement
7
Using a 3 mm hex wrench remove the four (4) screws that are attaching the X-axis tensioner bracket to
the X-axis channel in the control module or last expansion module.
8
Using the
Removing the X-axis Chain Assembly
the control module.
Removing the X-axis Belt Assembly
Required tools: 2.5 mm and 4 mm hex wrench and 4 mm spring load screw (already in tensioner)
To remove the X-axis belt
1
Using the 4 mm hex wrench, turn the spring load screw clockwise until the two parts of the tensioner
assembly touch.
20
on page 21 procedure remove the X-axis chain from
Installing a Multi-Module System
Advertisement
Table of Contents
