ADIC Scalar 100 User Manual page 206

Display of successful PING test:
Gateway > ping "192.168.1.1", 10
PING 192.168.1.1: 56 data bytes
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
----192.168.1.1 PING Statistics----
10 packets transmitted, 10 packets received, 0% packet loss
round-trip (ms) min/avg/max = 0/0/0
value = 0 = 0x0
Display of failed PING test:
Gateway > ping "192.168.1.251",10
PING 192.168.1.251: 56 data bytes
no answer from 192.168.1.251
value = -1 = 0xfffffff
16. If the PING test passed, go to step 21.
17. If the PINGtest failed, remove the Ethernet cable from the ADIC Gateway and
install the Ethernet loop back plug. From the service terminal, enter the
diagBoot command. Wait for the ADIC Gateway to finish booting. Verify that the
diagmode> prompt is displayed.
18. From the service port, enter the elTest command.
Diagmode > elTest
==== Testing Ethernet ====
External loopback LANCE-0
Ethernet OK
value = 0 = 0x0
19. If the test failed, replace the ADIC Gateway. Go to "Final Diagnostic Tests" on
page 208.
20. If the test passed, remove the Ethernet loop back plug. From the service
terminal, enter the normalBoot command and wait for the ADIC Gateway to
finish booting. Reattach the Ethernet cable to the ADIC Gateway.
21. From the service terminal, enter the gateAddrGet command and write down
the network gateway address that is displayed. Compare this address to the
190
Ethernet MAP