ADIC Scalar 100 User Manual page 248

Commands
This section describes the commands that are available to control, manage, and
service the ADIC Gateway. The commands are listed in alphabetical order for
easier reference.
Each command displays a status "value" in decimal and hexadecimal after
execution and before a new prompt is displayed. Usually a value of 0 indicates
success, but some commands may return a different value.
arptabShow
The arptabShow command displays the contents of the ARP table. The ARP
table contains the current Internet-to-Ethernet address mappings. This
information may be useful to the LAN administrator.
Gateway > arptabShow
192.168.1.19 at 8:0:20:23:2f:db
value = 0 = 0x0
Gateway
cd
You can move to a different directory (usually in the flash file system) using the cd
command.
Gateway
value = 0 = 0x0
Gateway
clearReservation [devId]
The clearReservation command can be used to force-clear a reservation
held by a host for the specified target device. It may be necessary to issue this
command if a host that has a reservation for a shared device was disconnected
from the ADIC Gateway without properly shutting down the application software
that issued the reservation. If this is the case, other hosts that attempt to access
the shared device will repeatedly receive reservation conflict status from the
device. Issuing this command may result in resetting the target device.
Gateway
value = 0 = 0x0
Gateway
232
>
> cd "MGMT"
>
Parameter
devId
> clearReservation 4
>
Value
The index of the device (LUN)
arptabShow