ADIC Scalar 100 User Manual page 286

setFcFrameSize [channel],[size]
Set the frame size for a channel using the setFcFrameSize command.
If an invalid size is set, then the fame size of 2048 will be used.
Gateway > setFCFrameSize 1,2048
value = 2048 = 0x800
Gateway >
setFcHardId [channel],[id]
Set the Hard AL_PA for a channel using the setFcHardId command.
Channel
ID number
The ID settings 0 to 125, inclusive, are valid IDs. [255] requests the Soft ID
method. If an invalid id is requested, then the Soft ID method will be used.
Gateway > setFcHardId 1,4
value = 0 = 0x0
Gateway >
setHost [port],
The setHost command sets the operating system type for the specified SAN
interface. This provides some customization in the way the ADIC Gateway is
270
Parameter
SAN Channel Number
Frame size
Attention: You must reboot the ADIC Gateway after executing this
command for the new setting to take effect.
Parameter
Attention: You must reboot the ADIC Gateway after executing this
command for the new setting to take effect
" OS "
Value
1 - 6
512,1024, or 2048
Value
1 - 6
0 to 125
255 Use Soft ID method
Meaning
setFcFrameSize [channel],[size]