ADIC Scalar 100 User Manual page 274

mapWinnowDatabase
Occasionally, you may want to eliminate inactive entries from the database. The
mapWinnowDatabase command reduces the database to only the devices
presently attached. The address mapping of the current devices will not be
altered.
Gateway > mapWinnowDatabase
0xc0ac8340 (tShell): Wrote 4 device maps to file 'ffs:config/
device.map'
value = 4 = 0x4
Gateway >
mbufShow
The mbufShow command displays statistics about the distribution of mbufs on the
Ethernet network. Interpreting these statistics requires detailed knowledge of
Internet networking protocols. This information may be useful to the LAN
administrator.
Gateway > mbufShow
type
---------
FREE :
DATA :
HEADER :
SOCKET :
PCB :
RTABLE :
HTABLE :
ATABLE :
258
tId
tLun
Handle
Itl
Attention: Winnowing the database might cause unattached devices
to change addresses unpredictably if they are reattached. Use this
command only when you are sure that the devices you are interested
in are connected and available to the ADIC Gateway. You must reboot
the ADIC Gateway after executing this command for the new setting
to take effect.
number
------
23
0
1
0
11
3
0
0
Target ID mapping for SCSI Initiators
Target LUN mapping for SCSI Initiators
An internal pointer used for some diagnostic
operations.
An internal pointer used for some diagnostic
operations.
mapWinnowDatabase