ADIC Scalar 100 User Manual page 309

value = 0 = 0x0
Gateway >
For termination status Information for Ultra SCSI channels, see the scsiTermGet
command.
xscsiTermSet [channel], [termination]
The xscsiTermSet command enables or disables the termination for an Ultra 2/3
SCSI Channel .
Channel numbers
termination 0
termination 1
Gateway > xscsiTermSet 5,1
Termination for XSCSI 5
will take effect upon channel reset
value = 0 = 0x0
Gateway >
To set termination status for Ultra SCSI Channels, see the scsiTermSet command.
xscsiTermSet [channel], [termination]
1 - 6 (Ultra2/3 SCSI)
= Enable Termination
= Disable Termination
Attention : You must reboot the ADIC Gateway after executing this com-
mand for the new settings to take effect
293