subnet 10.0.0 (implied netmask is 255.255.255.0) is sent to the host "bruno" for
forwarding. By default, no routes are defined in the route file.
The route command is invoked to add, remove, and list the route table.
route
The route " add " command adds a route to the destination through the gateway.
Gateway > route "add","200.0.0","bruno"
Gateway >
route
The route " delete " command removes a route to the destination through the
gateway.
Gateway > route "delete","200.0.0","bruno"
Gateway >
route
The route " list " command lists the existing routes.
Gateway > route "list"
Destination
-------------------- --------------------
socrates
Destination
-------------------- --------------------
200.0.0
value = 0 = 0x0
Gateway >
rz
The rz command initiates a receive Zmodem file transfer session. You use this
command when you want to download a file from the service terminal to the ADIC
Gateway. The file can be either a firmware or configuration file. After issuing this
command, you start the file transfer from the service terminal by initiating a send
file operation that uses Zmodem protocol.
The example below shows the
contains operational firmware. The ADIC Gateway extracts individual firmware
modules from the file and saves them temporarily in memory. After the file transfer
262
add
,
destination
"
"
"
delete
,
destination
"
"
"
list
"
"
Gateway
bruno
Gateway
bruno
,
gateway
"
"
"
,
gateway
"
"
command when it is used to receive a file that
rz
"
route "add","destination","gateway"