ADIC Scalar 100 User Manual page 321

supportDump
The supportDump command outputs the result of a number of Service Port
commands in a standard way and in a specific order. The resulting file is used for
troubleshooting. The individual commands called by supportDump are:
envShow
version
showBox
sysVpdShowAll
sysConfigShow
licenseShow
vpsShow
hostTypeShow
targets
scsiShow
fcShow
fcShowDevs
mapShowDevs
mapShowDatabase
showScsiAssign
fctShowChan
cleShowAll
loggerDumpCurrent
envMonShow
dmva
reserveShow
xscsiChannelTest (x,y)
The ADIC Gateway must be in diagnostic mode to use this command and you
must have the appropriate short VHDCI offset cable with 68-pin connectors, either
HVD or LVD/SE.
The xscsiChannelTest command performs a confidence test on a pair of Ultra 2/
3 SCSI channels. Substitute for x and y the Ultra 2/3 SCSI channel numbers you want
to test. Parenthesis are optional. This command can be used to test the Ultra 2/3 SCSI
interface or an Ultra 2/3 SCSI cable.
The example below shows the display for a test on Ultra 2/3 SCSI channels 1
and 4.
diagmode > scsiChannelTest 1,4
XSCSI-1 -> XSCSI-4 [##########] 101 iterations PASSED
XSCSI-4 -> XSCSI-1 [##########] 101 iterations PASSEDPASSED
value = 0 = 0x0
For Ultra SCSI channels, use the scsiChannelTest command.
Diagnostic Commands
305