ADIC Scalar 100 User Manual page 308

device should be available to host systems with the same LUN as the old
device.
To rescan Ultra SCSI channels, see the scsiRescan command.
xscsiResetDisableGet [channel]
The xscsiResetDisableGet command displays the SCSI Bus Reset On Power
Up setting for a specified Ultra 2/3 SCSI Channel. False means that SCSI Bus Reset
On Power Up is enabled. True means that SCSI Bus Reset On Power Up is disabled.
Gateway > xscsiResetDisableGet 5
SCSIbus
XSCSI 5
value = -1 = 0xffffffff
Gateway >
For information about Bus Reset Settings for Ultra SCSI channels, see the
scsiResetDisableGet command.
xscsiResetDisableSet [channel], [mode]
The xscsiResetDisableSet command sets the SCSI Bus Reset On Power Up
mode for an Ultra 2/3 SCSI Channel.
Gateway > xscsiResetDisableSet 5,1
Reset Disable set to TRUE for XSCSI
will take effect upon reboot
value = 0 = 0x0
Gateway >
To specify Bus Reset Settings for Ultra SCSI channels, see the
scsiResetDisableSet command.
xscsiTermGet [channel]
The xscsiTermGet command displays termination status information for the
specified Ultra 2/3 SCSI channel.
Gateway> xscsiTermGet 6
SCSIbus
XSCSI 6
292
Reset Disable
FALSE - default
Channel numbers 1 - 6 (Ultra2-SCSI)
Mode 0 = Enable Bus Reset On Power Up
Mode 1 = Disable Bus Reset On Power Up
Termination
Enabled
------- ---------------
5
------- ---------------
xscsiResetDisableGet [channel]