ADIC Scalar 100 User Manual page 284

will take effect upon reboot
value = 0 = 0x0
Gateway >
To specify Bus Reset Settings for Ultra2/3 SCSI channels only, see the xsc-
siResetDisableSet command
scsiShow
The scsiShow command displays all SCSI channels and information about the
devices attached to each channel. The following example shows the display for
two disk devices attached to SCSI Channel 1 and a tape library attached to SCSI
Channel 2:
Gateway > scsiShow
SCSI Initiator Channel 1: 0xc08b5b60
ID LUN Vendor
--------------------------------------|------------
1 0 OEM OEM DCHS04X
2 0 OEM OEM DCHS04X
SCSI Initiator Channel 2: 0xc08d26e0
ID LUN Vendor
--------------------------------------|------------
0 0 OEM
0 1 OEM
1 0 OEM
value = 0 = 0x0
Gateway >
268
nels only, see the xscsiResetDisableSet command
Product
Product
03570C12 5346 |
03570C12 5346 |
03570C12 5346 |
ID
LUN
Vendor
Product
Rev
Sync/Off
Rev | Sync/Off Width
6363 | 12/15 16 S W
6363 | 12/15 16 S W
Rev | Sync/Off Width
25/15 16 S W
25/15 16 S W
The SCSI ID of the target device
The SCSI LUN of the target device
The content of the Vendor ID field from the
SCSI Inquiry Data
The content of the Product ID field from the
SCSI Inquiry Data
The content of the Revision ID field from the
SCSI Inquiry Data
The negotiated synchronous transfer period
and offset. The period is the negotiated
transfer period. Multiply the period times 4
nanoseconds to determine the actual
period (exception: if the period is negoti-
ated to 12, then 50ns. is used). The offset
indicates the REQ/ACK offset that was
To specify Bus Reset Settings for Ultra2/3 SCSI chan-
0/ 0 8 S W Q
0/ 0 8 S W Q
0/ 0 8 S W
0/ 0 8 S W