ADIC Scalar 100 User Manual page 318

If errors are detected, the test displays the number of bad test iterations as shown
below. If your test was not successful, return to the MAP that sent you here.
diagmode > elTest
==== Testing Ethernet ====
Init complete.
Ethernet timeout error
Ethernet timeout error
Ethernet timeout error
Ethernet timeout error
Ethernet timeout error
Ethernet timeout error
Ethernet test reported 6 errors out of 12 iterations
value = 6 = 0x6
fcSlotTest [x]
The ADIC Gateway must be in diagnostic mode to use this command and a loop
back plug must be connected to the PMC card.
The fcSlotTest command performs a confidence test on a Fibre Channel slot.
Substitute for x the Fibre Channel slot number you want to test. This command
can be used to test the slot or the cable.
The following example code shows the display for a test Fibre Channel slot 1.
diagmode > fcSlotTest 1
FC 1 [##########] Iterations 51 Errors 0 - PASSED
Fibre Channel Port 1 returns PASSED
value = 0 = 0x0
diagmode > fcSlotTest 2
FC 1 [##########] Iterations 51 Errors 0 - PASSED
Fibre Channel Port 2 returns PASSED
value = 0 = 0x0
The following outputs are examples Fibre Channel port tests that were not
successful. If your test was not successful, return to the MAP that sent you here.
U 1
NSUCCESSFUL FIBRE TEST
diagmode > fcSlotTest 1
FC 1 [##########] Iterations 7799 Errors 7799 - FAILED
Fibre Channel Port 1 returns FAILED
value = -1 = 0xffffffff = pNullDmaDesc + 0xfe4ea9f7
Note: If the Fibre Channel "link" LED does not come on, the test will
not pass.
302
Diagnostic Commands