3. If the ADIC Gateway is not installed in a rack cabinet, check for loose or
broken feet.
4. Check the power cord for damage.
5. Check the external signal cable for damage.
6. Check the cover for sharp edges, damage, or alterations that expose the inter-
nal parts of the device.
7. Correct any problems that you find.
Internal Machine Check
Perform the following internal machine checks.
1. Check the condition of the inside of the machine for any metal or other
contaminants, or any indication of water, other fluid, fire, or smoke damage.
2. Check for any obvious mechanical problems, such as loose components.
3. Check any exposed cables and connectors for wear, cracks, or pinching.
Safety Label Check
Perform the following label check.
1. Verify that the safety label shown in Figure 1-1 is installed on the ADIC Gate-
way
2. If the safety label is missing, order and install it.
Safety Notices
7