Installation Steps For An Existing San Gateway; Figure 6-8: Vps Device Parameters Pop-Up - ADIC Scalar 100 User Manual

Figure 6-8: VPS Device Parameters Pop-Up

15. After you have finished assigning the desired access privileges, press the
Apply Changes
16. You now have to reboot the hosts or use some other host method to rescan
for devices before the host can see the new devices.
17. You have completed the VPS installation. If you need to add a new host or
remove a host from the SAN configuration, enter host parameters, etc., see
the appropriate section in this chapter for further information.
18. Save your configuration, as explained in "Save SAN Gateway Configuration"
on page 90.

Installation Steps for an Existing SAN Gateway

Note: This procedure assumes that the storage devices, ADIC Gateway and
hosts are turned on and the ADIC Management Console software has already
been installed. The hosts need to be online to inherit their current access
privileges when you enable VPS.
132
to be available to more than one host.
button. Press the button to return to the main screen.
Close
Installing Virtual Private SAN