ADIC Scalar 100 User Manual page 254

fcPortModeGet [port]
The fcPortModeGet command displays the mode for the specified Fibre
Channel port. The default port mode is Public Target. See also the
fcPortModeSet command
After the command executes, the number displayed as a value indicates the port
mode as follows:
The following example shows how the connection type is displayed when Fibre
Channel port 1 is specified and the port mode is Private Target.
Gateway >fcPortModeGet 1
value = 1 = 0x1
Gateway >
fcPortModeSet [port],[mode]
The fcPortModeSet command sets the mode for the specified Fibre Channel
port. See also the fcPortModeGet command.
The default port mode is Public Target. This means that if attached to a Fabric
device the ADIC Gateway will register as a Target with the name server. If the
port mode is Private Target, the ADIC Gateway does not register with the name
server and the Fabric device will not recognize the ADIC Gateway as a Target.
238
Attention: You must issue the fcRestart command or reboot the
ADIC Gateway for the new setting to take affect. See the fcRestart
command for further information.
.
Parameter Value
Port 1- 6
Value
1
2
3
17
18
19
Meaning
The SAN Connection number
Port Mode
Private Target
Private Initiator
Private Target and Initiator
Public Target
Public Initiator
Public Target and Initiator
fcPortModeGet [port]