ADIC Scalar 100 User Manual page 149

1. The default Channel Zoning settings allow any-to-any access. If you did not
change the default settings, go to step 2.
Otherwise, if you have changed Channel Zoning settings to create restricted
access zones, confirm that you want to keep those settings and restrictions. If
you want to keep those settings, go to step 2.
You can use a combination of Channel Zoning and VPS but VPS can only
control access permissions between devices in the same access zone. See
the section on "Combining VPS with Channel Zoning" on page 145. You may
want to consider removing Channel Zoning access restrictions. If you do, you
need to reboot the ADIC Gateway after changing the settings.
Note: If you need to reboot the ADIC Gateway, VPS will not be able to inherit
host access permissions. You will have to manually assign access for them. If
this is the case, exit this procedure and go to the section "Installation Steps for
an Existing SAN Gateway" on page 132.
2. If the ADIC Management Console Server and Client are already running and
you are already logged in with administrative privileges go to step 3. If not,
start the Server and Client, login as the administrator and connect to the ADIC
Gateway.
3. From the ADIC Management Console, select the ADIC Gateway. From the
Controls
4. In the dialog box, enter the License Key for your specific ADIC Gateway.
Note:
the word enable rather than an actual license key.
5. Install the Host Registration Service on each host. See "Installing the Host
Registration Service" on page 123.
Note: If you do not install the Registration Service you have to enter host
parameters manually. See "Entering Host Parameters" on page 137.
6. After the hosts have finished booting. From the ADIC Management Console,
select the ADIC Gateway. From the
7. After the ADIC Gateway has been refreshed, expand the tree to show tree ele-
ments. Expand the tree for the Fibre Channels and verify that all registered
Installing Virtual Private SAN
menu, select
Feature Enable > Virtual Private SAN
If this feature is factory enabled, you can activate it by simply entering
.
menu, select
View Refresh SAN Gateway
.
133