12. Reboot and wait for firmware to start.
Gateway > reboot
13. Manually invoke repeated data path tests. Use the repeat command to
iterate the ddfc command. In this example ddfc will be run 200 times. If an
error occurs then the Gateway will be rebooted and re-enter the
Bus_Fault_Detected state.
Gateway> repeat 200,ddfc
0 Bit errors
0 Bit errors
0 Bit errors
0 Bit errors
0 Bit errors
:
:
:
0 Bit errors
value = 0 = 0x0
Gateway >
14. If errors occur, visit "Service and Support" at www.adic.com, or call the ADIC
Technical Assistance Center at 1-800-827-3822.
196
Data Path Protection MAP